2004 Kia Sorento Camshaft Position Sensor Location

The Actual Sensor Pig Tail Continues Down Below, Underneath The Plastic Lower Timing Belt Cover, On The Front Of The Motor, Just Above The.

I just replaced the alternator and the camshaft position sensor. That is only the pig tail plug in. It is located on the left or drivers side at the front of the engine.

Also Please Check Out The Statistics And Reliability Analysis Of Kia Motor Sorento Based On All Problems Reported For The Sorento.

This is where the camshaft position sensor is located and how to remove it. P0014 means that the camshaft position is too far advanced from where it should be in Code p0340, replaced crankshaft position sensor, when vehicle gets hot it stalls.

This Includes The Kia Sorento.

It is responsible for gathering information about the car's camshaft speed, which it then sends to the engine control module. The crankshaft position sensor is under the timing cover near the crank gear the labor to change the crankshaft sensor is 4.6 hours and would cost around 460 dollars if you are changing the crankshaft sensor you should do the timing belt also because the labor is the same. When the sorento’s ecm determines that there is an issue with the signal coming from this sensor, it’ll throw the p0335 trouble code.

Sealed Connections To Prevent Leaks, Environmental Corrosion And Performance Issues.

Before you screw the sensor back in place, make sure the blue wire is. Check the timing belt alignment. All lights radio and heat continued to work but car stalled.

This Sensor Uses A Reluctor To Gauge The Position Of The Crank.

Problem first occluded when driving and all the sudden car just stalled. One of the two camshaft position sensors is situated on the right (driver) side of the engine near the front corner. (if you are standing at the passenger fender area, this will be on your left on the side of the engine nearest the.